CAT CBC70MBE 70-Amp Professional Battery Charger (with Engine Start) Instruction Manual
Download PDF user manual for Caterpillar CAT CBC70MBE 70-Amp Professional Battery Charger with 1440 Watt Engine Start (EN|ES) 36 pages RD072715 2015 zip
Description
This PDF instruction manual is for the CAT CBC70MBE Battery Charger (with Engine Start).
About the Item
CAT CBC70MBE 70-Amp Professional Battery Charger with 1440 Watt Engine Start
This battery charger has a high charge rate of up to 70 amps, and 1440 watts of engine starting power.
Read all instructions before operating product. Save this manual for future reference.
DOCUMENT(S) AVAILABLE
(PDF) INSTRUCTION MANUAL / MANUAL DE INSTRUCCIONES
Available Languages
ENGLISH (EN) | ESPAÑOL (ES)
SUMMARY OF CONTENTS
SAFETY GUIDELINES / DEFINITIONS
– Risk of unsafe operation
IMPORTANT SAFETY INSTRUCTIONS
– General safety warnings and instructions for all battery chargers
– Specific safety instructions for power cords
– Ground fault circuit interrupter (GFCI)
– Extension Cords
– Recommended Minimum AWG Size for Extension Cords for Battery Chargers
– Power Cord Safety
– Specific safety instructions for battery chargers
– Use of accessories and attachments
– First aid: Skin, Eyes, LCD liquid crystal display.
PREPARING TO CHARGE
– Charger Location
– Connection Precautions
FOLLOW THESE STEPS WHEN THE BATTERY IS INSTALLED IN A VEHICLE:
– Through Bank 1 Using the Built-in Battery Clamps
– Through Bank 2 and/or Bank 3 Using the Clamp Cable Set with O-ring Connectors
FOLLOW THESE STEPS WHEN THE BATTERY HAS BEEN REMOVED FROM A VEHICLE:
– Through Bank 1 Using the Built-in Battery Clamps
– Through Bank 2 and/or Bank 3 Using the Clamp Cable Set with O-ring Connectors
INTRODUCTION
CONTROLS AND FUNCTIONS
– Features
– Accessories
– Digital display detail
OPERATING INSTRUCTIONS
SINGLE-BANK AND MULTI-BANK MODE SELECTION
This battery charger can perform operations utilizing any or all of three charging Banks, allowing multiple tasks to be performed simultaneously.
– Single-Bank Mode (Default)
– Multi-Bank Mode (Up to 3 Simultaneous Connections – Bank 1, 2 and/or 3)
CHARGING THE BATTERY
– Single-Bank Battery Charging
– Multi-Bank Battery Charging
INDICATIONS AND FAULTS – ALL MODES
RECONDITIONING THE BATTERY
Periodic reconditioning is recommended to maintain a battery’s optimum performance. Battery recondition sends a series of electrical pulses to break up the crystalline form of lead sulfate and turn these chemicals into useful battery electrolytes.
CHECKING THE ALTERNATOR
STARTING THE ENGINE
TROUBLESHOOTING
Unit Fails to Charge
– Check that the charger is properly connected to a live 120 volt AC outlet.
– Make sure a proper polarity cable connection has been established.
– Make sure all connections are secure.
– If the battery to be charged has fallen below 2 volts, the battery cannot be recharged with this charger.
CARE AND MAINTENANCE
ACCESSORIES
SERVICE INFORMATION
WARRANTY
SPECIFICATIONS
– Input: 120VAC, 60Hz, 1180W
– Output: 12VDC, 70A*, 200A Engine Start (5 seconds on, 5 minutes off)
*Refer to the table in the “Single-Bank and Multi-Bank Mode Selection” section of this manual for charging rate information specific to each Bank.
Why download the Manual?
This instruction manual provides all the information from CAT / Caterpillar about the CBC70MBE Battery Charger (with Engine Start), as detailed in the table of contents. Reading it completely will address most questions you might have. You can download and save it for offline use, including viewing it on your device or printing it for your convenience if you prefer a paper version.
How to download the Manual?
Download it by clicking the button below
Helped you out?
Glad to hear that. It would be awesome if you could . . .
